Drawer control connected with thermal printer or serial port.

Call us now! +44 (0) 2037347158

Post published:23/04/2020
Post category:Installation / Uninstallation / Issues

1. When the drawer is connected with serial port, sposbridge settings is required to connect to the EMDI.

The settings for the sposbridge.ini file are as follows:

[Drawer]
hexcommands=$1B$70$00$0D$0A$0C
parity=None
stopbits=1
databits=8
BaudRate=9600
Port=COM1
Title=drawer

[Drawer]

hexcommands=$1B$70$00$0D$0A$0C

parity=None

stopbits=1

databits=8

BaudRate=9600

Port=COM1

Title=drawer

*Where parity, stopbits, databits, BaudRate, Port the computer’s serial port settings and title a simple text-title

2. When the drawer is connected to a thermal printer, it is sufficient to make a correct adjustment for its opening in the printer settings from the control panel, as well as to be configured to print the corresponding documents in the EMDI settings.

** Attention: if there is a sposbridge (or even oposbridge), the variable title should not be set in the corresponding .ini file (it should be Title =).